(3D Printed) RED WEIGHT BOX for Stomper 4x4 and 50 similar items

*Keep in mind 3D printed parts will have texture. Think of them like model car parts. May need a light sanding, A xacto knife trimming small supports or paint if you wish. Usually 1 side was attached to the printer bed and it may be the roughest. Lightly sand and usually fine. Thanks again for your interest. 1 New 3D printed weightbox with lid for Stomper pull sets. Slides onto the original attachment. Box ships unpainted and bare black plastic. Says "Stomper" on the lid. Lid fits tighter than original so it wont fall off. May have white Elmer's glue on bottom. Wash in warm water it comes right off. Other colors available. Message before buying to check stock 3D printed plastic parts can break if you get too rough wirh them but Ive had mine on and off a dozen times without failure. Do not use tools such as screw drivers to pry them out. It will arrive unbroken. No warranty beyond that.