*Due to phones or monitors showing color shades differently, colors may vary from what is on your screen. *Keep in mind 3D printed parts will have texture. Think of them like model car parts. May need a light sanding, A xacto knife trimming small supports or paint if you wish. Usually 1 side was attached to the printer bed and it may be the roughest. Lightly sand and usually fine. Thanks again for your interest. Please ask about colors available.. New 3D Printed Semi Trailer Repair Pin as shown. Fit and function as originals but are PLA plastic so be gentle. Thank you! Gently trim your broken pin out. Slide in mine. Super glue into place. Allow to dry 24 hours before using. Then be slow a couple times to be sure its solid.