For fastening bushings and bearings exposed to high temperatures. High-strength bonding Can only be removed once heated up to 300C High temperature range up to 200C Strength at 100C still 85 % of maximum strength Maximum joint filling capacity of 0.2 mm Completely fills extensive surface roughnesses Prevents frictional corrosion The bearings will not seize up Fast curing High resistance Resistant to a large number of bases, gases, solvents, oils and fuels (see resistance list) Silicone-free, solvent-free and oil-free DOS system: Practical, one-hand operation thanks to the practical turn closure, therefore always one hand free to grip with. Continuously adjustable dispensing system enables dispensing to be adjusted to suit the application and to keep consumption and costs to a minimum. Cost optimisation through almost complete emptying, no residual material remains in the dispensing neck. Notice The following plastics can be affected in the event of prolonged exposure: ABS, celluloid, polystyrene, polycarbonate (Macrolon), PMMA (Plexiglas), polysulfone, SAN (lurane, Tyril), Vinidur, vulcanised fibre and painted surfaces. We always recommend that you conduct your own tests. Conforms to the formula recommended by the German Environmental Protection Agency for use in applications which come into contact with drinking water dated 11 February 2016. If it is being used as a thread sealant which comes into contact with water, please observe the relevant recommendations from the association of the adhesive and sealant industry. The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. If our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products. Please observe the technical data sheet! Weight of content 50 g Chemical basis Methacrylic acid ether Colour Green Density/conditions 1.11 g/cm / in accordance with DIN EN ISO 2811-1 Suitable for max. thread M36 Max. gap-filling ability 0.2 mm Min./max. viscosity /conditions 10000-16000 mPas / at 25C, Brookfield RVT, spindle 5/20 rpm Fully hardening/curing conditions Exclusion of oxygen and contact with metal (copper or iron ions) Min./max. initial strength 30-40 min Min./max. functional strength 1-3 h Min./max. final strength 12 h-24 h Min./max. processing temperature 5 to 35 C Min./max. temperature conditions -55 to 200 C Min. flashing point 90 C Breakaway torque min./max. / conditions 25-60 Nm / DIN EN 15865 Min. prevail torque 20 Nm Conditions for prevail torque DIN EN 15865 Min./max. compressive shearing strength /conditions 25-50 N/mm / in accordance with ISO 10123 Shelf life from production/conditions 18 Month / at room temperature Solvent-free Yes Silicone-free Yes