Here we have a strong metal bracket for hanging a wheel cover tyre SUITABLE FOR ALL VEHICLES INCLUDING MOTORHOMES CAMPERVANS, VANS , 4x4 This can be bolted on any part of your vehicle:- Rear door of a vehicle Inside panel of a vehicle Front Bonnet of a vehicle Top Roof of a vehicle Caravans , horse carriers and SUVs/MPVs Are you fed up with having your tyre at the bottom underside or otherwise inside your vehicle? This will allow you to hang your wheel cover complete with rim and tyre anywhere on the vehicle Comes with the 3 bolts for holding the tyre in place FITS ALMOST ALL TYRES !! Grab this unusual and rare item not found easily and with a bit of diy make it a great enhancement to your vehicle Going on a long journey and need an additional spare tyre (holder)? / Space? Measurements: Bottom Metal piece for attaching to the vehicle - 5 holes for bolts predrilled 8 inches (20cm ) by 6 inches (15 cm) Top Metal Piece 5.25 inches (13.2cm) x 5.25 inches (13.2cm) 3 holes predrilled with bolts and nuts supplied to hold all any standard tyre Gap Protrusion bar between the two metal pieces welded together measures 5.25 inches (13.2 cm) PCB MEASUREMENTS The three holes pre drilled where the bolts (supplied) are put in measure as follows:- Bottom two holes have a gap of 7 cm Top to bottom left and right holes measures 11 cm Further holes can be easily drilled to suite any rim size although at least two bolts must hold the tyre HEALTH AND SAFETY NOTICE It is the responsibility of the buyer to ensure that the item is suitable for your vehicle Ensure that the product is fully and properly secured Ensure that you have flat supporting plates on the other side of your vehicle if your vehicle panel is thin Ensure that the tyre and item is fully secure before commencing on any journey BUY FROM A RELIABLE AND WELL ESTABLISHED BUSINESS IN STOCK NOW FOR IMMEDIATE POSTAGE!