PMS Immersible Coolant Pump Seal less Design USED 1/4 HP $199 GERMAN MADE. IT LOOKS LIKE IT WAS REFURBISHED...... PREVIOUS OWNER. THE PROP LOOKS NEW... Features Benefits Standardized installation dimensions (DIN EN 12157) Durable and robust, wear-resistant design Pump shaft with motor-side bearing On demand incl. drive control PMS seal less, multi-stages centrifugal pumps are made of metal with an open impeller. These pumps were designed for the conveying of slightly to highly contaminated media such as emulsions, including with chemical additives, oils, water with a corrosion protection additive, water-based paints and heat carrier oils. The seal less design chosen for the PMS pumps, with a motor-side bearing, ensures high wear resistance and a long service life even under the toughest erosion and rinse wear stress conditions. Abay Electronics is an asset recovery wholesaler specializing in new and used surplus industrial equipment. We are not a representative of any manufacturer listed; all names, logos, descriptions and other related information are trademarks of their respected companies or manufacturers. All items listed are identified as either new or used and the new may be older surplus. We list all items to the best of our ability and aim to provide the customer with as much information as possible. Yaba1957 is not liable for any products sold, the customer is responsible for proper testing, installation and use of equipment purchased. No warranties are expressed or implied.The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies. If so, do not bid on this item unless you are an authorized purchaser. If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping of the item.