1:200 Scale Plastic Snap-Fit ? Boeing 737-800 ? Length:7.5" Wingspan: 6.75" These models from Flight Miniatures are made of plastic and don't need any glue or paints. The assembly is very basic and takes only a few minutes. Assembly consists of nothing more than attaching the wings to the fuselage and then attaching the tail and elevators. Special care has to be taken while attaching the wings since the fitting in these models is quite tight and some pressure needs to be applied. The pressure needs to be applied on the wings and onto the fuselage. Do not, for example, hold the wings from the engines and apply force like that since this will damage and/or break the engine. This is not a toy. Recommended for 15 and up. The Boeing 737 is an American narrow-body airliner produced by Boeing at its Renton factory in Washington. Developed to supplement the Boeing 727 on short and thin routes, the twinjet retained the 707 fuselage width and six abreast seating but with two underwing Pratt Whitney JT8D low-bypass turbofan engines. Envisioned in 1964, the initial 737-100 made its first flight in April 1967 and entered service in February 1968 with Lufthansa. The lengthened 737-200 entered service in April 1968, and evolved through four generations, offering several variants for 85 to 215 passengers.